Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Ignis F7 E5
FAQ TREEWhat does error code F7 E5 mean on a Ignis appliance?
Ignis error code F7 E5 indicates: Ignis Platinum & Tuttigiorni Washing Machine: Shifter actuator position fault F7 E5; washer fails to transition between agitate and spin modes..
What is the root cause of Ignis error code F7 E5?
The primary root cause for Ignis code F7 E5 is: On Ignis washers (Ignis Tutti i Giorni reliable electro-mechanical and digital platform architecture): Synchronous shift actuator motor failed (open coil), broken optical switch arm, or stripped splutch cam gears under transmission..
How do I fix or resolve Ignis error code F7 E5?
To resolve error code F7 E5: Measure shift actuator motor winding resistance across pins 2 and 3: nominal 2,000–3,000 Ω (2.0–3.0 kΩ). Verify optical sensor 5V DC pulse on pin 4 during rotation. Turn program knob to Reset/Drain, hold Start button for 5 seconds until drain completes, then switch off.
Is it safe to clear Ignis error code F7 E5 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Ignis code F7 E5 persists, the physical component causing On Ignis washers (Ignis Tutti i Giorni reliable electro-mechanical and digital platform architecture): Synchronous shift actuator motor failed (open coil), broken optical switch arm, or stripped splutch cam gears under transmission. must be inspected or replaced.
How do I test electrical resistance for Ignis code F7 E5 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing Ignis code F7 E5?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



