Schaub Lorenz i10

Schaub Lorenz error code I10 indicates: Schaub Lorenz SLD / AquaStar Integrated & Freestanding Dishwasher: Diagnostic fault code i10 registered by the microcomputer controller. Dishwasher water fill timeout; required wash level not reached in 6 minutes (code i10).

The primary root cause for Schaub Lorenz code I10 is: On Schaub-Lorenz consumer domestic appliances engineered for German and European households engineered with integrated wash hydraulics, 1850W heating element (27-30 Ω), synchronous wash pump with capacitor (120-150 Ω), 30W magnetic drain pump (160-210 Ω), microswitch float flood tray, and optoelectronic sensor: water tap closed, supply hose kinked behind machine, or inlet solenoid coil disconnected. Metrological tolerance verification: inlet solenoid coil resistance 3.5 kΩ to 4.5 kΩ at 20°C; incoming water flow rate >6 L/min..

To resolve error code I10: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: verify water tap is fully open, ensure supply hose has no bends, and measure solenoid coil resistance (~4.0 kΩ). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold Start/Cancel button for 4 seconds until the display shows '0:01' or drain phase initiates, clearing internal microprocessor error code.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Schaub Lorenz code I10 persists, the physical component causing On Schaub-Lorenz consumer domestic appliances engineered for German and European households engineered with integrated wash hydraulics, 1850W heating element (27-30 Ω), synchronous wash pump with capacitor (120-150 Ω), 30W magnetic drain pump (160-210 Ω), microswitch float flood tray, and optoelectronic sensor: water tap closed, supply hose kinked behind machine, or inlet solenoid coil disconnected. Metrological tolerance verification: inlet solenoid coil resistance 3.5 kΩ to 4.5 kΩ at 20°C; incoming water flow rate >6 L/min. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.