Atlantic AL08

Atlantic error code AL08 indicates: Atlantic Naema / Perfinox / Effinox / Varmax Gas Condensing & Hybrid Boiler: Diagnostic fault code AL08 registered by the microcomputer controller. Domestic sanitary hot water plate heat exchanger NTC thermistor fault.

The primary root cause for Atlantic code AL08 is: On Atlantic appliances engineered with Siemens gas burner management microcomputer, stainless steel premix condensing heat exchanger, flame rectification ionization electrode (≥ 3.0 µA DC), and 10 kΩ primary heating NTC thermistors: sanitary domestic hot water plate heat exchanger NTC sensor degraded by lime encrustation or moisture intrusion Metrological tolerance verification: NTC thermistor 10 kΩ at 25°C, 5.8 kΩ at 40°C, 2.5 kΩ at 60°C..

To resolve error code AL08: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure resistance across DHW sensor terminals and check cable continuity to main control module. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold the illuminated 'Reset' button on the boiler fascia for 3 to 5 seconds until 'rSt' flashes on the digital display and burner pre-purge begins. If lockout repeats, verify gas cock is fully open and inlet pressure is 20 mbar natural gas / 37 mbar propane before further resets.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Atlantic code AL08 persists, the physical component causing On Atlantic appliances engineered with Siemens gas burner management microcomputer, stainless steel premix condensing heat exchanger, flame rectification ionization electrode (≥ 3.0 µA DC), and 10 kΩ primary heating NTC thermistors: sanitary domestic hot water plate heat exchanger NTC sensor degraded by lime encrustation or moisture intrusion Metrological tolerance verification: NTC thermistor 10 kΩ at 25°C, 5.8 kΩ at 40°C, 2.5 kΩ at 60°C. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.