Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Candy E22
FAQ TREEWhat does error code E22 mean on a Candy appliance?
Candy error code E22 indicates: Candy RapidÓ / Smart Pro / GrandÓ Vita Inverter Washer: Siphoning drain detection E22; water level drops continuously during active wash fill cycle without pump activation..
What is the root cause of Candy error code E22?
The primary root cause for Candy code E22 is: On Candy washing machines featuring Speed-Drive Inverter brushless motor, Smart Touch NFC / hOn Wi-Fi connectivity, and GIAS Cuore electronic platform: Drain hose installed too low (<65 cm height), drain hose pushed too far into standpipe creating airtight siphon seal..
How do I fix or resolve Candy error code E22?
To resolve error code E22: Ensure top of drain hose bend is suspended between 65 cm and 100 cm above floor level. Use anti-siphon curved elbow and provide air gap in standpipe. Turn dial to Off, press and hold Start/Pause and Extra Rinse simultaneously for 5 seconds until display flashes '888', then power cycle.
Is it safe to clear Candy error code E22 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Candy code E22 persists, the physical component causing On Candy washing machines featuring Speed-Drive Inverter brushless motor, Smart Touch NFC / hOn Wi-Fi connectivity, and GIAS Cuore electronic platform: Drain hose installed too low (<65 cm height), drain hose pushed too far into standpipe creating airtight siphon seal. must be inspected or replaced.
How do I test electrical resistance for Candy code E22 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Candy code E22?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



