Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: FAGOR AL01
FAQ TREEWhat does error code AL01 mean on a FAGOR appliance?
FAGOR error code AL01 indicates: Fagor Innova Total No Frost / FFA Multi-Airflow Refrigerator: High temperature alarm in freezer compartment AL01; internal temperature rises above -9°C and audible buzzer sounds..
What is the root cause of FAGOR error code AL01?
The primary root cause for FAGOR code AL01 is: On FAGOR refrigeration units featuring Innova Total No Frost dual-evaporator system, dynamic cooling column, and intelligent automated defrost cycle: Door left ajar, magnetic perimeter gasket damaged, loss of refrigerant gas charge (R600a), or weak compressor pump..
How do I fix or resolve FAGOR error code AL01?
To resolve error code AL01: Check door closure and verify magnetic seal airtightness with a paper strip. Allow 12 hours for stabilization if newly stocked. If compressor runs continuously without cooling, leak test system. Press and hold the Super Freeze and Alarm Mute pads together for 6 seconds until the beep confirms diagnostic memory cleared.
Is it safe to clear FAGOR error code AL01 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if FAGOR code AL01 persists, the physical component causing On FAGOR refrigeration units featuring Innova Total No Frost dual-evaporator system, dynamic cooling column, and intelligent automated defrost cycle: Door left ajar, magnetic perimeter gasket damaged, loss of refrigerant gas charge (R600a), or weak compressor pump. must be inspected or replaced.
How do I test electrical resistance for FAGOR code AL01 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing FAGOR code AL01?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



