Sauter d27

Sauter error code D27 indicates: Sauter Confort / Saveurs / SFW Inverter Washer: Door unlock timeout at cycle completion d27; door remains securely locked after wash program finishes and drum stops..

The primary root cause for Sauter code D27 is: On Sauter washing machines featuring Confort SFW low-noise inverter drive, dynamic balance monitoring, and energy-optimized wash hydraulics: Residual water detected by pressure switch, slow-cooling PTC bi-metal pill, or mechanical latch binding against rubber seal..

To resolve error code D27: Wait 3 minutes for PTC to cool. Push firmly on door panel while pulling handle to relieve latch pressure. Inspect drain filter for water buildup. Position dial on Stop, press and hold Start/Pause and Spin Speed keys for 5 seconds until '00' flashes, then restart machine.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Sauter code D27 persists, the physical component causing On Sauter washing machines featuring Confort SFW low-noise inverter drive, dynamic balance monitoring, and energy-optimized wash hydraulics: Residual water detected by pressure switch, slow-cooling PTC bi-metal pill, or mechanical latch binding against rubber seal. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.