Access our premium database of error codes, common faults, and professional repair solutions for Siemens appliances.
Pyrolytic cleaning aborted / Door fault
There is a fault with the door contact switch or the door locking motor during a pyrolytic cycle.
Allow the oven to cool completely. Power cycle the appliance. If the fault persists during the next attempt, a service technician is required.
Siemens F0: Operational cycle fault detected during Hob / Cooktop program execution.
The hob has detected a non-specific internal error in its electronics.
Disconnect the hob from the mains power for 30 minutes to reset it. If the error returns upon reconnection, a service engineer is needed.
Hob has overheated and switched off
The internal electronics of the hob have become too hot due to prolonged use on high power or blocked ventilation slots.
Turn off the hob and allow it to cool down completely for at least 30 minutes. Ensure the ventilation slots underneath are not obstructed.
Cooking zone has overheated and switched off
The hob has detected an overheated cooking zone and has switched off as a safety measure. Could also be a sensor issue.
Remove the cookware from the affected zone. Let the hob cool down. If the error persists even when cold, there is a fault with the control electronics.
Cooking zone turned off after long use
The hob has been operating continuously for an extended period, and the automatic safety switch-off has been activated.
This is a normal safety feature. To continue cooking, simply turn the cooking zone on again.
Door is not closed properly
The door latch is not correctly engaged in the lock mechanism, or the door lock is faulty.
Open the door and close it again firmly. Check for any clothing caught in the door. If the error continues, the door lock assembly may need replacement.
Motor fault / Drum not turning
The motor's carbon brushes are worn out, or there is a fault with the motor or the control module.
Requires a technician. The motor's carbon brushes likely need to be replaced. Check motor connections and test motor.
Temperature sensor (NTC) fault
The temperature sensor that measures the water temperature is faulty, providing incorrect readings.
Requires a technician to test the sensor's resistance and wiring. The sensor will likely need to be replaced.
Motor cannot turn drum / Drum is blocked
An object is stuck between the drum and the tub, the motor is blocked, or the motor tacho sensor is faulty.
Attempt to turn the drum by hand (with power off). If it's blocked, an object needs to be removed. Otherwise, it's a motor or electronics fault requiring a technician.
Controls are locked, oven won't respond
The child safety lock is activated.
Press and hold the button with the key symbol for approximately 4 seconds until the symbol disappears from the display.
'SAFE' appears on the display after a power outage
The oven has entered a safety mode following a power interruption.
This is a normal state. You must reset the clock to the current time to clear the 'SAFE' message and enable oven functions.
Water supply fault indicator is lit
Indicates an issue with the water supply. Water tap may be off, inlet hose kinked, or inlet filter blocked.
Check that the water tap is fully open. Straighten the inlet hose. Clean the filter at the connection point to the machine.
Hob incorrectly connected to mains supply
The hob has been wired with incorrect voltage or phasing during installation.
Immediately disconnect the appliance from the power. The connection must be checked and corrected by a qualified electrician.
Cooking zone not working, power level flashing
No pan is on the cooking zone, the pan is not suitable for induction, or the pan is too small for the zone.
Place a suitable, induction-compatible pan in the center of the cooking zone. Ensure the base is flat and covers the zone markings.
Our official certified partners service Siemens appliances in your area.